Installing a Speedometer Drive Gear on a 727
I pulled out the plug that was in my 727 speedo cable surface area, from when I rebuilt information technology as at the time I didn't have the speedo gear, or housing.
now I practise, what is the order and how does all install using proper seal, o ring, prune etc?
some "layouts" I detect show the seal below housing others above and both have it ii unlike directions...
Linkback: https://forum.e-bodies.org/engine-transmission-and-rear-stop/4/727-speedo-gear-install/6854/
001.jpg (58.64 kB, 800x710 - viewed 130 times.)
« Final Edit: May 16, 2018, 08:07:49 AM by culp71 »
Logged
The big orange o-ring goes around the housing to seal it to the trans example. The modest black o-ring goes inside the housing and seals the speedo gear to the housing. The o-band installs from the outside. The prune goes in Afterwards the seal is in.
I like to put a piffling trans fluid on the gear shaft before installing information technology into the housing.
When installing the housing into the trans example, yous'll run across some #s cast into the housing. This corresponds to the # of teeth on the speedo gear. This is how y'all decide how to orient the housing in the instance.
The black seal goes in from the threaded cease with the lip facing down.... The ring retains information technology.... The O ring should exist cocky explanatory... When installing the adapter in the trans you need to align it based on the gear molar count, it should match up with one of three groups stamped into the adapter.... That grouping needs to align with the index mark on the tail housing...
Logged
East-Bodies Cuda Challenger Message Forum
Logged
so this would exist right
It's from the service manual, why would you question information technology?
Logged
didn't know if it was correct was only a google search but I also found this 1 too...why I was confused
Logged
GO WITH YOUR Offset Flick
Logged
Eastward-Bodies Cuda Challenger Bulletin Forum
didn't know if it was correct was simply a google search but I also found this i likewise...why I was confused
Wow... Looks similar a service transmission photo but good luck trying to make that work.... Crazy... I encounter your point..
Logged
2nd instance is the Chinese-Fiat version.
Logged
Sheldon
I assume the transmission needs to be drained to do this. Correct?
Logged
Who has more fun than people!
74 Challenger Rallye
12 Challenger RT Classic
15 Challenger SXT
68 Charger RT
79 Macho Power Wagon clone
No need to bleed the trans. A little fluid will come up out but not a lot. Put a pan under the speedo housing as you remove information technology.
Logged
E-Bodies Cuda Challenger Message Forum
Can I just slide the old gear out and the new i in without removing the retaining ring and seal?
Logged
Yes, the gear will pull correct out of the housing. Brand sure you lot look at the numbers on the side of the housing and become it in the right orientation when you reinstall it. Depending on what gear is in it at present, and what gear y'all are replacing information technology with, you might have to alphabetize the housing to a different spot.
Logged
E-Bodies Cuda Challenger Bulletin Forum
DOWNLOAD HERE
Installing a Speedometer Drive Gear on a 727 UPDATED
Posted by: melvinstlited39.blogspot.com